Receiver Blank Flats

MAC10

This is a true original spec Cobray reciever flat to make a full size MAC 10 (M10) in .45 cal. or 9mm. This is actually better quality than the mass produced stamped vintage units that often had sharp edges. Made with quality steel and precisely machined. NO FFL or paperwork is required.

Reviews

There are no reviews yet.

Be the first to review “MAC10”

Your email address will not be published.

$50.00

3 in stock

3 in stock

MAC11

This is a true original spec Cobray reciever flat to make a long frame MAC 11 (M11/9) in 9mm. It is actually better quality than the mass produced stamped vintage units that often had sharp edges. Made with quality steel and precisely machined. NO FFL or paperwork is required.

Reviews

There are no reviews yet.

Be the first to review “MAC11”

Your email address will not be published.

$50.00

Out of stock

MAC12

This is a true original spec Cobray reciever flat to make a MAC 11A1 (M11A1) in .380 cal. This is actually better quality than the mass produced stamped vintage units that often had sharp edges. Made with quality steel and precisely machined. NO FFL or paperwork is required.

Reviews

There are no reviews yet.

Be the first to review “MAC12”

Your email address will not be published.

$50.00

9 in stock

KP44

This flat is laser cut and includes a partially precut ejector slot, front magwell tabs and correct shape. Material is 14 ga (.075) A569 hot roll steel. In addition to forming, the ejector slot is cut out and the front magwell tabs are bent in to complete the bare shell. The original KP-44 design features a (semi) removable barrel with rivets and pin. NO FFL or paperwork is required.

Reviews

There are no reviews yet.

Be the first to review “KP44”

Your email address will not be published.

$35.00

7 in stock

PPSH41

This laser cut flat which can be formed into a receiver repair section for the parts kits. Material is 12 Ga (.095″) A-36 Hot roll steel. This flat is 7″ long and includes the ejecion slot and the opening for the trunnion upper rivet projection. NO FFL or paperwork is required.

Reviews

There are no reviews yet.

Be the first to review “PPSH41”

Your email address will not be published.

$35.00

18 in stock

PPS43

This flat is laser cut and includes a partially precut ejector slot, front magwell tabs and correct shape. Material is 14 ga (.075) A569 hot roll steel. In addition to forming, the ejector slot is cut out and the front magwell tabs are bent in to complete the bare shell. NO FFL or paperwork is required.

Reviews

There are no reviews yet.

Be the first to review “PPS43”

Your email address will not be published.

$35.00

8 in stock