Uzi

These display receivers have been machined from a bar of 1018 cold rolled steel. These display receivers were made from the help of Philadelphia Ordnance and are exactly reproductions are their receivers from the early 2000’s.

NO FFL or paperwork is required.

The machining operations present are:

• forward end threaded for barrel sleeve
• circular barrel channel machined from threaded forward end to exposed feed ramp
• forearm mounting lugs and bayonet mount machined
• ejection port machined
• interior area machined above the magazine well opening and feed ramp on bottom (area approximately 3-1/2” x 1-1/2”)
• channel approximately 4-3/8” x 5/16” machined into upper forward area (cocking lever guide)
• cavity approximately 5/8” x 3/4” x 1/2” machined at the forward shoulder of the cocking lever guide channel
• lug machined for trigger housing takedown pin
• sear openings partially machined in bottom
• solid receiver section behind magazine well opening
• rectangular hole approximately 1/2 x 5/16x 1/4 ” machined into near lower rear edge
• circular hole approximately 1/2” in diameter and 1/2” deep machined into rear wall

Operations that would define these display receivers as a gun:
• The reminding bolt channel would have to be machined away.
• Front and rear sights would have to be added.

Price $399